JJAP Conference Proceedings

JJAP Conf. Proc. 4, 011402 (2016) doi:10.7567/JJAPCP.4.011402

Development of evaluation system for automobile corrosion environment

Harutaka Takahashi, Ruri Nakada, Nobutoshi Konagai

  1. Component Engineering Development Department, Suzuki Motor Corporation, Hamamatsu 433-8111, Japan
  • Received October 27, 2015
  • PDF (1.1 MB) |

Abstract

With the global changes of the automobile market, the design and development of an automobile in consideration of various corrosive environments are required. It is necessary to immediately grasp the corrosive environment of the automobile market quantitatively. Therefore, even a system that could measure the corrosive environment of transit-time has been developed. Various areas of a corrosive environment were measured continuously and quantitatively by using this system, and every the side of the automobile could be evaluated. In this study, the result of the measurement of an ACM sensor (Atmospheric Corrosion Monitor Sensor) that estimated the corrosive environment in particular to automobiles is reported.

Creative Commons License Content from this work may be used under the terms of the Creative Commons Attribution 4.0 license. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI.

References

  1. 1 S.-i. Motoda, Y. Suzuki, T. Shinohara, and S. Tsujikawa, Zairyo-to-Kankyo 47, 651 (1998).
  2. 2 S. Suzuki et al., Discussion of Zairyo-to-Kankyo 53, C-104 (2006).
  3. 3 JFE technical report, No. 16 pp. 64–65, (2007).
  4. 4 N. Konagai et al., Under patent application.
  5. 5 S. Suzuki et al., Galvatech07, C-7-3.
  6. 6 S. Suzuki et al., The 165th Corrosion Anticorrosion Symposium Data, Association of Corrosion Anticorrosion, Tokyo, 2008.
  7. 7 D. Mizuno et al., Corrosion Science 83, (2014).
  8. 8 T. Shinohara, Nishiyama Memory Technology Lecture: The Iron and Steel Institute of Japan 211–212, 48 (2012).
  9. 9 K. Fukuda et al., 2015 JSAE Annual Congress (Spring), 2005, S384.
  10. 10 P. Kah et al., Rev. Adv. Mater. Sci. 36, 152 (2014).
  11. 11 Proc. 16th Euro Car Body 2014, 2014.